Loading...
typing...
Search
 
+

Jack plate convertable MJ5 HD manual: 300 HP MAX  -  AED 2,300

Ras al Khaimah Ras al Khaimah >
Motors Motors >
Boats Boats >
Motorboats Motorboats >
Other Other >
Details
https://dbzstatic-a.akamaihd.net/.dist_fb67595f1eebca743b65c42dcff8f3f686d6da78/ 9924922
  • 3 Photos
3 Photos - Click to enlarge

Details: Posted on: 13th June 2018

  • Age: Brand New
  • Usage: Still with the dealer
  • Condition: Perfect inside and out
  • Length: 30-39 ft.
  • Seller Type: Owner
  • Warranty: No

Description:

Description
Convertable manual MJ5 jack plate is actually 4 units in one! It can be 2.5″” setback or 5″” setback. And it can have a straight or negative 6 degree wedge.

They are anodized black for race oriented looks. Easy adjustments are made on the side of the jack plate.



2 1/2 inch offset no wedge
A feature which is used on the lightest of boats. Allowing the engine to be raised to its maximum height without putting the weight of the engine too far behind the transom which could create too much bow lift.

2 1/2 inch Offset with Negative 6-Degree Wedge This design can be used when the transom of a boat is too steep of an angle to allow the outboard motor to perform properly. For example: an 18-degree transom when this design is applied.

5-inch Offset No Wedge
This option desirability will vary from one boat to another depending upon weight and length of boat. Some outboard motors have a limited trim angle and the 6-degree wedge may not allow for enough bow lift. By setting the plate at the no wedge design, it will give maximum bow lift.

5-inch Offset with 6-Degree Wedge

Jacking bolts– allow motor to be moved to any height. No need to take boat out of the water.

Offset– positions motor 5 1/2 inches behind transom. This allows prop to run in cleaner water, away from the turbulence and bubbles created by the hull. This helps stop slippage of prop, and helps stop torque in steering wheel at high speeds.

Trim-In– this allows motor to be trimmed in or down 6 degrees more than if mounted flat on transom. Helps stop low speed porpoising. Balance load better.

Light-weight– approximately 25lbs., constructed of aircraft grade aluminum and stainless steel.

Anodized– anodized black finish to prevent corrosion. Anodize also lets paint stick to aluminum if painting is preferred.

Narrow designed– only inches wide, make this plate possible to fit the narrowest of transoms.

Fits V-6– pre-drilled to fit all late model V-6’s. Can be modified to fit any size outboard.

Converting the new 4 in 1 is as easy as dropping anchor!

Adjustable plates turn 180 degrees and switch sides, then bolt in place.

Overall width: 17-7/8”(45.3cm)

Overall height:14”(35.5cm).

All manual jac plates have 2 ½“(6.3cm) of lift built in and 4”(10.1cm) of adjustable lift.

Lifetime warranty on structure

Made in USA.

Rated for 300HP, upto 625 lbs motors (heavier should use Extreme series)

Share with friends

 

Reply to this Ad:

Scam Warning:
(Examples of scams)

Never wire money or financial info to a seller on the internet. For your security, all transactions should be done in person.

Please report scams.

Show Phone Number
or
Chat With Seller Show Phone Number

Location
Al Hamra‪,‪ Ras al Khaimah
Show map